Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual download pdf (Page 11)

ICC

• Turn the power on only after attaching the front cover.

• Follow all warnings and precautions and do not exceed

equipment ratings.

• The ASD maintains a residual charge for a while after turning

supply power off. After turning supply power off, wait at least

ten minutes before servicing the ASD or interface board.

Ensure that the Charge LED is off prior to beginning

installation.

• For further ASD-specific precaution, safety and installation

information, please refer to the applicable Adjustable Speed

Drive Operation Manual supplied with your ASD.

3.2 Maintenance Precautions

• Use lockout/tagout procedures on the branch circuit

disconnect before servicing the ASD or installed interface

board.

• The ASD maintains a residual charge for a while after turning

supply power off. After turning supply power off, wait at least

ten minutes before servicing the ASD or interface board.

Ensure that the Charge LED is off prior to beginning

maintenance.

• Do Not attempt to disassemble, modify, or repair the interface

board. Contact your ICC or Toshiba sales representative for

repair or service information.

• Turn the power on only after attaching the front cover and Do

Not remove the front cover of the ASD when the power is on.

• If the ASD should emit smoke or an unusual odor or sound,

turn the power off immediately.

• The ASD heat sink and discharge resistors may become

extremely hot to the touch. Allow the unit to cool before

coming into contact or performing service on the ASD or

interface board.

• The system should be inspected periodically for damaged or

improperly functioning parts, cleanliness, and to determine

that all connectors are tightened securely.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 99 100

No comments

Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual Page 11