Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual download pdf (Page 30)

100

ICC

10.4.5 Parameter List Filter

A filter function provides Parameter List search capabilities. To use the filter

function, simply type a word or portion of a word into the filter entry box and

then click the “filter” button. Refer to Figure 14.

The filter will then display only

those parameters currently

available in the Parameter List

that satisfy the search criteria.

For example, to find all monitor

parameters that contain some

derivative of the word “volt” (such

as “voltage” or “volts”), select the

“Monitor Parameters” group, the “All” su/jointfilesconvert/1321780/bgroup, and then enter “volt” in the filter

entry box.

Once a filter has been entered, it will continue to be applied to all information

normally displayed in the Parameter List for as long as the filter term is left in

the filter entry box. Continuing the previous example where we filtered on the

root term “volt” in the monitor parameters, we can then easily apply this filter to

all parameters (configuration, command or monitor) simply by selecting the “All”

parameter group. The Parameter List will now display all configuration,

command or monitor parameters that contain the root term “volt”.

To remove the filter, delete any characters contained in the filter entry box and

then click the “filter” button.

10.4.6 Radix Selection

Figure 15 shows the radix selection buttons.

These selection buttons allow changing the

Parameter List “value” column data display

and entry radix between decimal and

hexadecimal formats.

When “DEC” is selected, the “value” column

heading will be “Value (Decimal)”, current parameter values will be displayed in

decimal, and values to be written to parameters must be entered in decimal

format. For example, to change the drive’s frequency command to 40.00Hz,

enter the decimal value 4000

Similarly, when “HEX” is selected, the “value” column heading will be “Value

(Hexadecimal)”, current parameter values will be displayed in hexadecimal, and

values to be written to parameters must be entered in hexadecimal format. For

example, to turn on bits #15, #14 and #10 in the drive’s command word, enter

the hexadecimal number C400

Figure 14: Parameter List Filter

Figure 15: Radix Selection

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 99 100

Comments to this Manuals

No comments

Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual Page 30

Comments to this Manuals

Related products and manuals for Hardware Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH