Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual download pdf (Page 48)

ICC

The Condition Must Remain True For A Minimum Of: Alarm analysis

processing is performed by the interface card once per second. Enter the

number of seconds that the condition must be continuously evaluated as “true”

for the alarm to be triggered. A time of 0 seconds means that just a single

evaluation of “true” will immediately trigger the alarm.

Send Additional Reminders While The Condition Remains True:

If this

check box is unchecked, then only one email transmission event will occur

when an alarm condition is triggered: further email transmissions will not be

attempted for this alarm unless the alarm condition is first evaluated as “false”

(which resets the alarm), and then once again is triggered by a subsequent

event.

If this check box is checked, then as long as the alarm condition continues to

be evaluated as “true”, subsequent email transmissions will be automatically

retriggered every indicated number of minutes for a maximum of the indicated

number of times. If at any time during the subsequent transmissions the alarm

condition is evaluated as “false”, then the alarm will be reset and email

transmissions for this alarm will stop (until the next time the alarm is triggered,

of course).

Subject:

Enter a string of up to 128 characters in length which will appear in

the “subject” line of the alarm email. The body of the alarm email is empty.

10.9.5 Submitting Changes

Whenever any of the Alarm configuration elements (alarm settings or email

configuration parameters) have been changed, the “submit” button located in

the lower right-hand portion of the web page must be clicked in order to write

these settings to the interface card’s filesystem.

Note that because these configuration elements are read from the filesystem

only when the interface card boots up, the act of submitting configuration

changes will also reset the interface card. Please allow 30 seconds for the

interface card to reboot, at which time it will then be operating with the recently-

submitted configuration. Refer to Figure 45.

Figure 45: Submit Configuration Changes

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

No comments

Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual Page 48