Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual download pdf (Page 68)

ICC

Click OK when done.

Figure 63: Module Properties Connection Tab

6) After adding the I/O Module

to the configuration, the full

I/O Configuration tree should

appear similar to Figure 64.

7) Switch to online mode and download

the project to the PLC. Verify that the

newly-added drive is available and

operating correctly by observing any

indications shown on the drive’s icon.

When the drive’s icon is selected, its

status and any available error

messages will be displayed in the

area below the project tree. Refer to

Figure 65. Also confirm that the

interface card’s “Network Status” LED

should be solid green, indicating an

“online/connected” state.

8) By double-clicking “Controller Tags” in the project tree, it is possible to view

the newly-added tags. Refer to Figure 66. The ASD_G9ETH:C

configuration tag is unused, the ASD_G9ETH:I tag allows viewing of the

input data, and the ASD_G9ETH:O tag allows modification of the output

data. These tags will be synchronized with the drive at whatever rate was

established for the module’s RPI.

Figure 64: I/O Configuration Tree

Figure 65: Online Module Status

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 99 100

No comments

Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual Page 68