Toshiba SR-M8102 User Manual

TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SR-M8102 CD-R/CD-RW DRIVE USER MANUAL

8 Figure 3.Using Emergency Eject Cleaning Media Try to avoid touching the read area (underside) of the disc as dirt and smears will degrade the d

9 TROUBLESHOOTING – SR-M8102 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instruction

10 SPECIFICATIONS –SR-M8102 General Interface ATAPI Format for Writing: Disc at once, Track at once, Session at once, Variable & Fixed Packe

11 Transfer Rate CD-ROM Read (Mode 1) CD-R/RW Read (Mode 1) 7,800KB/second 6,000KB/second Random Access Time CD-ROM CD-RW 110ms 120ms Data Buffe

12 Connectors DC input 4-pin Power Supply Connector ATAPI Interface Connector 40 Pin I/F ATAPI Standard Audio Connectors 4-pin and 2-pin connector

13 DRIVE CONNECTORS –SR-M8102 Figure 1.SR-M8102 CD-R/CD-RW Drive Rear Panel - Connectors Power Connector Power is supplied to your CD-R/RW driv

14 Table 1.Interface Pin Assignments INTERFACE PIN ASSIGNMENT PIN NO. I/O SIGNAL NAME HOST SIGNAL NAME PIN NO. I/O SIGNAL NAME HOST SIGNAL NAME 1

CONTENTS Introduction...1 Setup ...

1 INTRODUCTION – SR-M8102 General Features CD-R/CD-RW disc write/rewrite at 52X/32X 3-way Disc Eject (eject button, software, emergency eject hole

Front Panel Figure 1.SR-M8102 CD-R/RW Drive Front Panel Loading Tray Load disc using tray. LED The LED lights when the drive is operating Loa

3 SETUP – SR-M8102 The following steps must be performed to properly install your drive: • Set Drive Jumper Settings • Connect Audio Cable • At

4 Placing CD-R/CD-RW Drive inside your Computer Now that you have set the jumpers, you are ready to install your CD-R/CD-RW drive inside your compute

5 Power Cable - Connect an internal computer power supply cable to the power socket at the back of the CD-R/CD-RW drive. One side of the plug has ch

6 USING THE CD-R/CD-RW Drive – SR-M8102 Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is mounted horizontally

7 Figure 2.Inserting Disc Vertically Removing a Disc To remove a disc from the CD-R/CD-RW drive, perform the following steps: 1. Open the Loading T