Toshiba ICC Multiprotocol Ethernet Interface ASD-G9ETH User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
9
ICC
3. Precautions and Specifications
Rotating shafts and electrical equipment can be hazardous.
Installation, operation, and maintenance of the ASD and interface
board shall be performed by Qualified Personnel only.
Qualified Personnel shall be:
Familiar with the construction and function of the ASD and
interface board, the equipment being driven, and the hazards
involved.
Trained and authorized to safely clear faults, ground and tag
circuits, energize and de-energize circuits in accordance with
established safety practices.
Trained in the proper care and use of protective equipment in
accordance with established safety practices.
Installation of ASD systems and associated interface boards
should conform to all applicable National Electrical Code (NEC)
Requirements For Electrical Installations, all regulations of the
Occupational Safety and Health Administration, and any other
applicable national, regional, or industry codes and standards.
DO NOT install, operate, perform maintenance, or dispose of this
equipment until you have read and understood all of the following
product warnings and user directions. Failure to do so may result
in equipment damage, operator injury, or death.
3.1 Installation Precautions
Use lockout/tagout procedures on the branch circuit
disconnect before installing the interface board into the ASD.
Avoid installation in areas where vibration, heat, humidity,
dust, metal particles, or high levels of electrical noise (EMI)
are present.
Do not install the ASD or interface board where it may be
exposed to flammable chemicals or gasses, water, solvents,
or other fluids.
Where applicable, always ground the interface board
appropriately to prevent electrical shock to personnel and to
help reduce electrical noise. The ASD’s input, output, and
control power cables are to be run separately from the
interface board’s associated cables.
Note: Conduit is not an acceptable ground.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

Comments to this Manuals

No comments