Toshiba MK6017MAP User Manual download pdf (Page 116)

360014937

- 616 -

10.13 Master/Slave Configuration

Drive address shall be set by the optional jumper of interface connector.

The drive runs as Master drive when the jumper is open or if jumper plug is set to position B-D when

P28(CSEL) signal is low. The drive runs as Slave drive when the jumper plug is inserted into position C-D

or if jumper plug is set to position B-D when P28 (CSEL) signal is high. In case of two- drive

configuration, one shall be Master and the other should be Slave.

ATA /ATAPI specifies to use P28 with jumper plug set to position B-D. It is recommended to follow the

ATA / ATAPI specification.

Jumper P28 Drive

No Jumper - Master Drive

C-D Jumper - Slave Drive

B-D Jumper LOW Master Drive

B-D Jumper HIGH Slave Drive

Prohibit A-B Jumper - -

Prohibit A-C Jumper - -

Figure 6 Optional jumper for Master/Slave

Polarity key

1 C A

2 D B

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 125 126

No comments

Toshiba MK6017MAP User Manual Page 116