Toshiba Tecra 8100 User Manual Page 98

  • Download
  • Add to my manuals
  • Print
  • Page
    / 226
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 97
6-14 Power and Power-Up Modes User's Manual
Tecra 8100 User's Manual 8100_UK.DOC ENGLISH Printed on 13/12/99 as
IM8100UK
2.
Press
Enter
and the following message appears.
Set Password Again? (Y/N)
Press
Y
to run the TSETUP program and set a new password.
Press
N
to restart the computer.
The password service diskette must be inserted in drive A, otherwise the
display will return to
Password
=
. If you have inserted the diskette in
drive A and the message still appears, the password service diskette is
faulty. In this case, contact your dealer.
If the boot priority is set for the hard disk, press the reset button and hold
down
F
to boot from the diskette drive.
Power-up modes
The computer has two operating modes: Boot mode and Resume mode.
You can set the mode by pressing
Fn
+
F3
to activate the feature and,
while holding down
Fn
, pressing
F3
again to change the mode. You can
also select the mode by the TSETUP program . See Chapter 7, TSETUP
and Passwords
,
for details.
The power-up mode functions described in this section are similar to the
Shutdown
and
Suspend
(
Standby
)
functions in Windows 95/98. Refer
to your Windows documentation for details.
Boot mode
Boot mode is the standard operating mode for most computers.
In boot mode, you must always save your work and exit the application
you’re using before you turn the computer off. Any work you don’t save
before shutting the system off is lost.
Starting the computer in boot mode
Follow the steps below to turn on the computer in boot mode.
1.
Turn on any peripheral devices connected to the computer.
2.
If you have attached an external diskette drive, check that there is no
diskette in the drive unless you want to boot from a diskette.
3.
Press the power switch on the computer.
When the
Power
indicator lights and all disk activity has stopped, the
computer is ready to begin work.
Page view 97
1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 225 226

Comments to this Manuals

No comments