Toshiba Qosmio G50 User Manual download pdf (Page 171)

User’s Manual 9-9

Qosmio G50

Point to note about memory module error

If you install a memory module that is not compatible with the computer, the

Power indicator will flashes (on for 0.5 seconds, off for 0.5 seconds) in the

following ways;

■ If there is an error in only Slot A or no memory module is inserted in

Slot A: repeatedly flashes orange twice, then white.

■ If there is an error in Slot B: repeatedly flashes orange, then white

twice.

■ If there are errors in both Slot A and Slot B: repeatedly flashes orange

twice, then white twice.

In all instances you should shut down the computer and remove the

incompatible module(s).

Installing a memory module

The computer contains slots for two memory modules, one positioned

immediately over the other - the procedures are the same for installing

either module.

1. Shut down the computer - make sure the Power indicator is off (refer to

the Turning off the power section in Chapter 3, Getting Started, if

required).

2. Remove the AC adaptor and all cables and peripherals connected to

the computer.

3. Close the display panel.

4. Turn the computer upside down and remove the battery pack (refer to

Replacing the battery pack section in Chapter 6, Power, if required).

5. Loosen the screw securing the memory module cover in place - please

note that this screw is attached to the cover in order to prevent it from

being lost.

6. Slide your fingernail or a thin object under the cover and lift it off.

Figure 9-6 Removing the memory module cover

Use a point size 0 Phillips screwdriver to remove and fasten the screws -

the use of an incorrect screwdriver can damage the screw heads.

Memory module cover

Screw

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 249 250

No comments

Toshiba Qosmio G50 User Manual Page 171