(4) Loosen the lock screw according to ceiling board
thickness for attaching to the ceiling.
(5) The IK-DP20A is temporarily attached to the
topside of the housing using the
screws that were included with the IK-DP20A.
(6) Do not fully tighten the screw.
(JK-H01Atop housing install)
(7) Two support arms are contained inside
and attaches to the ceiling. Fig-2
Lock
screw
Support
Arms
Fig-2
(8) Put the video cable, power cable, and the
communication cable inside the housing from the
hole on the topside. Break a hole in the center of
the housing and let the cable pass through
(9) Push out the support arms so that they
hold onto the ceiling. Fig-3
Support Arms
Fig-3
-28-
Comments to this Manuals