Toshiba W1443 User Manual download pdf (Page 14)

English - 14 -

English

Initial Installation

Before switching on the TV, put your decoder and media recorder to Standby if they are connected and

ensure the aerial/cable and/or Satellite dish is connected to your TV. To set up the TV, use the buttons on

the remote control as detailed on The Remote Control page.

IMPORTANT: Ensure that the aerial/cable and/or

Satellite dish is connected and a Common Interface

module is not inserted before switching on the TV for

the rst time installation.

1. Connect the mains plug, press and hold the

middle of the control switch on the left side of

the TV to switch the TV on. If the TV does not

switch on, press any numbered or

button on

the remote control, then the language selection

menu will be displayed. This screen will appear

the rst time that the TV is switched on and each

time the TV is reset.

2. By pressing Up or Down button, highlight the

language you want to set and press OK button.

The following screen will be displayed next:

3. By pressing Left or Right button, select the

country you want to set and press Down button

to highlight the Search Type option. Use Left or

Right to set the desired search type. Available

search types are Digital only, Analogue TV

only and Full.

4. When set, press Down button to highlight

Teletext Language. Use Left or Right button to

select desired language region. Highlight Scan

Encryted Channels and enable/disable this

option by using Left or Right buttons. Press OK

to continue.

Note: Depending on the Country selection you may be asked

to set and conrm a PIN at this point. The selected PIN cannot

be 0000. You have to enter it if you are asked to enter a PIN

for any menu operation later.

5. The following message will be displayed next on

the screen:

Select Store mode if the TV will be placed in a

store to exhibit. This option will congure your

TV’s settings for best display quality and the

supported features of the TV will be displayed on

the top of the screen as a info banner. If Store

mode is selected, a conrmation screen will be

displayed. Select YES to proceed. For home use

select Home Mode.

This option will be available in Other Settings

menu and can be turned off/on later.

6. Press OK button on the remote control to continue

and the following message will be displayed on

the screen:

7. Select Yes by using Left or Right button and

press OK button to continue. Afterwards, the

following OSD will be displayed on the screen:

8. If you select Cable option, a conrmation screen

will be displayed. If you want to search for

available networks, select YES to proceed. The

following screen will be displayed:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments

Toshiba W1443 User Manual Page 14

Comments to this Manuals

Related products and manuals for Monitors Toshiba W1443