Toshiba P55-A5200 User's Guide download pdf (Page 55)

Getting Started

Removing a memory module

6 Turn the computer right side up. Make sure to remove

the soft cloth from the work surface before restarting the

computer.

Always make sure your computer and AC adaptor have

adequate ventilation and are protected from overheating

when the power is turned on or when an AC adaptor is

connected to a power outlet (even if your computer is in

Sleep mode). In this condition, observe the following:

Never cover your computer or AC adaptor with any object.

Never place your computer or AC adaptor near a heat

source, such as an electric blanket or heater.

Never cover or block the air vents including those located

at the underside of the computer.

Always operate your computer on a hard flat surface.

Using your computer on a carpet or other soft material

can block the vents located at the underside of the

computer.

Overheating your computer or AC adaptor could cause

system failure, computer or AC adaptor damage or a fire,

possibly resulting in serious injury.

7 Reconnect the cables.

8 Restart the computer.

TECHNICAL NOTE: You must have at least one memory

module installed for the computer to work.

Checking total memory

When you add or remove a memory module, you can check

that the computer has recognized the change. To do this:

Press the ( ) +

X keys, and then click System.

The

System window appears. Installed memory

(RAM)

is displayed below the System heading.

If the computer does not recognize the memory

configuration, turn off the computer and remove the memory

module slot cover (complete steps 1-10 in “Installing a

memory module” on page 48), and then check that the

module is inserted completely into the socket and lined up

squarely with the socket latches.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 195 196

No comments

Toshiba P55-A5200 User's Guide Page 55