Toshiba TOSLINE S20 User Manual download pdf (Page 40)

TOSLINE-S20 Active Star Coupler (ASC25) Instruction Manual 6F3B0360

TOSLINE S20 39

9.8 Precautions on laying cables

For handling optical connectors and cords, refer to the "7.4 Precautions on handling

optical fiber and connector" of the instruction manual.

(1) Precautions on laying cables

• For the case of cable with connector, the front end cord and optical connector portions shall

be carefully prepared not to apply direct force to the portions.

• Cables shall be laid in straight pattern as far as possible.

(2) Check of transmission loss

To monitor the connection condition of aligner after wired and to detect abnormality in

transmission loss caused from contamination on the connector edge faces, light power shall be

measured. The determination of the light power is done as follows.

Devices to be prepared

Light power meter 2 units (one shall have a reference light emission function)

Reference single-core cord 2 cords (each having a length of about 1 meters)

(A) Check of light power meter

One of the two light power meters shall be used as the light source, and the two

shall be connected as shown in the figure below, thus confirm the light emission

power.

Reference single-core cord

Light power meter (transmission side)

Light power meter (receiving side)

Figure 9.17 Measurement of light emission power

Two reference cords shall be used to determine the light emission power.

Two cords for checking confirm that the reference cord is in normal state. Normally, both

cords give similar results.

(B) Determination of transmission loss in actual optical transmission line

The above-described power meters shall be placed at both ends of the optical

transmission line to determine the transmission loss. The difference between the

value observed at that moment at receiving side and the value observed at

receiving side with the reference cord becomes the transmission loss in actual

transmission line.

Transmission loss in actual transmission line = (Observed value with the

reference cord) − (Observed value in the transmission line)

1 2 ... 35 36 37 38 39 40 41

No comments

Toshiba TOSLINE S20 User Manual Page 40