Use the SELECT AT switches to
select 001 to 255
7-3-2 ADDRESS
Move the cursor to the position in Fig.
7-3-3 Protocol
Move the cursor to the position in Fig.
Use the SELECT switches to seiect
TOSHiBA-P, TOSHiBA-D
7-3-4 BIT RATE
Move the cursor to the position in Fig.
Use the SELECT switches to select
1200, 2400, 4800, 9600bps
In RS-422 control, it is necessary to set
a unique camera address I and bit rate
for each camera.
7-3-5 SOFT VER.
Software version display
8. Remote control:
D/N CONTROL RS422
ADDRESS [iliH
PROTOCOL
TOSHIBA-P
BIT RATE 4800
SOFT VER.
* * * *
EXIT DEFAULT
D/N CONTROL RS422
ADDRESS 001
PROTOCOL
■toshiba-p
BIT RATE 4800
SOFT VER.
He =1= =1=
EXIT DEFAULT
D/N CONTROL RS422
ADDRESS 001
PROTOCOL
TOSHIBA-P
BIT RATE EEIiTil
SOFT VER.
* * H= H=
EXIT DEFAULT
This camera supports 2-type remote control.
8-1 RS-422 Control (Factory-setting) supported TOSHIBA-P and
TOSHIBA-D
- 17-
RxRx G
2 wires
Controller
Tx of the communication line from KBD is connected to Rx of the camera, and
Tx- is connected to Rx- of the camera.
Internal switch location
Internal
A controllable function is as follows.
Preset Number Function
71 GO Backlight compensation ON (zone: BLC2)
72 GO Backlight compensation OFF
75 GO Software version display
88 GO IR cut filter ON (Color mode)
89 GO IR cut filter OFF (BA/V mode)
95 SET Enter MENU mode
-18-
Comments to this Manuals