Toshiba MK4006GAH User Manual Page 104
- Page / 153
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Toshiba Corporation Digital Media Network Company
Page 104 of 153
© 2003, Copyright TOSHIBA Corporation All Rights Reserved
bit 3 (off-line read scanning implemented bit)
If this bit is cleared to zero, the device does not support off-line read scanning. If this bit is set to one, the
device supports off-line read scanning. This bit is set to 1.
bit 4 (self-test implemented bit)
If this bit is cleared to zero, the device does not implement the Short and Extended self-test routines. If this
bit is set to one, the device implements the Short and Extended self-test routines. This bit is set to 1.
bits 5 (reserved).
This bit is set to 0.
bits 6 (Selective self-test implemented bit)
If this bit is cleared to zero, the device does not implement the Selective self-test routine. If this bit is set to
one, the device implements the Selective self-test routine. This bit is set to 1.
bits 7 (reserved).
This bit is set to 0.
BYTE 368-369: SMART capability
bit 0 (power mode SMART data saving capabilities bit)
bit0 = 1 SMART data is saved before Power save mode changes.
bit0 = 0 SMART data is NOT saved before Power save mode changes.
This bit is set to 1
bit 1 (SMART data autosave after event capability bit)
This bit is fixed to 1
bit 2-15 Reserved
BYTE 370 Error logging capability
BYTE 371 Self-test Failure Checkpoint
This byte reports the checkpoint when previos self-test failed.
BYTE 372-373: Self-test routine recommended polling time
The self-test routine recommended polling time is equal to the number of minutes that is the minimum
recommended time before which the host should first poll for test completion status. Actual test time could
be several times this value. Polling before this time could extend the self-test execution time or abort the
test depending on the state of bit 2 of the off-line data capability bits.
BYTE 374-510: Reserved
BYTE 511: Data structure checksum
Checksum of the first 511 byte
- TOSHIBA 1
- MK6006GAH/MK4006GAH 1
- /MK3006GAL 1
- Revision History 2
- IMPORTANT MESSAGES 3
- LIMITATION OF LIABILITY 3
- USAGE RESTRICTIONS 4
- TABLE OF CONTENTS 7
- Table of Figures 10
- 2. SCOPE 11
- 3. GENERAL DESCRIPTION 11
- Page 12 of 153 12
- 4. KEY FEATURES 13
- 5. BASIC SPECIFICATION 15
- 6. PERFORMANCE 16
- 7. POWER REQUIREMENTS 17
- 8. MECHANICAL SPECIFICATIONS 18
- 8.3.1 Installation 19
- MK3006GAL Dimensions 20
- 9. ENVIRONMENTAL LIMITS 22
- 9.4 Altitude 23
- 9.5 Acoustics 23
- Sound Power 23
- 9.6 Safety Standards 24
- EMC Adaptability 25
- 9.7 Magnetic Fields 25
- 10. RELIABILITY 26
- 10.6 Load/Unload 27
- 11. HOST INTERFACE 28
- 11.2.2.1 Input 29
- 11.2.2.2 Output 29
- 11.3 Interface connector 30
- 11.3.2 Pin Assignment 31
- 11.3.3 Signal Treatment 32
- 11.3.4 Series resistance 33
- 11.3.5 Signal Description 33
- 11.4 Host Interface Timing 35
- 11.5 Grounding 48
- 11.6 Address Decoding 49
- 11.7 Register Description 50
- 11.7.2 Error Register 51
- 11.7.2.1 Operational Mode 51
- 11.7.2.2 Diagnostic Mode 51
- 11.7.7.2 SMART commands 54
- 11.7.8 Device/Head Register 54
- 11.7.9 Status Register 55
- 11.7.10 Command Register 56
- Command Code 57
- 11.8 Command Descriptions 60
- 11.8.1 Nop (00h) 61
- 11.8.2 Recalibrate 61
- (1xh) 61
- 11.8.3 Flush Cache (E7h) 61
- 11.8.9 Read Verify (40h) 64
- 11.8.11 Write Verify 65
- (3Ch) 65
- 11.8.12 Format Track 65
- (50h) 65
- 11.8.13 Seek (7xh) 66
- 11.8.14 Toshiba Specific 66
- 11.8.18 Read Multiple (C4h) 69
- 11.8.23 Read DMA (C8h/C9h) 73
- 11.8.25 Write DMA (CAh/CBh) 74
- 11.8.27 Power Control (Exh) 75
- 11.8.27.3 Stand-by (E2/96) 76
- 11.8.27.4 Idle (E3/97) 76
- 11.8.27.6 Sleep (E6/99) 76
- 11.8.28 Read Buffer (E4h) 77
- 11.8.29 Write Buffer (E8h) 77
- 11.8.31 SET MAX (F9h) 91
- 11.8.31.1 Set Max Address 91
- 11.8.31.3 Set Max Lock 92
- 11.8.35 Set Features (EFh) 96
- Sector offset(15:8) 121
- 11.9.4 Password lost 137
- 11.9.5 Command Table 138
- 11.10.1 Attributes 139
- 11.10.2 Attributes values 139
- 11.11.1 Performance Idle 140
- 11.11.2 Active Idle 140
- 11.11.3 Low Power Idle 140
- 11.11.4 Transition time 140
- 11.12 Reset 141
- 1 C A 142
- 2 D B 142
- 11.14 Cache Memory 143
- 12. Protocol 144
- 12.1 PIO data in commands 145
- 12.2 PIO data out commands 145
- 12.3 Non-data commands 147
- • READ DMA EXT 149
- • WRITE DMA EXT 149
- 12.5 Ultra DMA 150
- 12.6 Other timings 153
Related products and manuals for Hardware Toshiba MK4006GAH
Hardware Toshiba MK8025GAS User Manual
(11 pages)
(11 pages)
Hardware Toshiba MK2016GAP User Manual
(11 pages)
(11 pages)
Hardware Toshiba ETB004Z User Manual
(18 pages)
(18 pages)
Hardware Toshiba SD-M1612 User Manual
(17 pages)
(17 pages)
Hardware Toshiba SD-R2212 User Manual
(12 pages)
(12 pages)
Hardware Toshiba SD-R2612 User Manual
(13 pages)
(13 pages)
Hardware Toshiba A8-EZ8511 User Manual
(9 pages)
(9 pages)
Hardware Toshiba PCX260 User Manual
(22 pages)
(22 pages)
Hardware Toshiba XLTR-200 User Manual
(99 pages)
(99 pages)
Hardware Toshiba SD-R1002 User Manual
(16 pages)
(16 pages)
Hardware Toshiba CD332 User Manual
(32 pages)
(32 pages)
Hardware Toshiba RTM20 User Manual
(14 pages)
(14 pages)
Hardware Toshiba T2N User Manual
(272 pages)
(272 pages)
© 2020, manymanuals.com. All rights reserved. | 1.709 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals