Toshiba IK-64DNA User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
8-2 B.C.G Control
D/N control setup of a sub menu is set to B.C.G and an internal switch is set
to the BCG side, the foliowing remote controi is possible about D/N mode.
Terminal B
Terminal C
MODE
OFF (H)
OFF (H)
AUTO
OFF (H) ON (L)
COLOR
ON (L)
OFF (H)
B/W
ON (L) ON (L)
B/W
(1)
BCG
(2)
BCG
(3)
BCG
m
0
ffl
-cr^ò—o
All modes
0
rn
ON—B/W
OFF-AUTO
777
9. NOTE ON USE AND INSTALLATION
Do not aim the camera at the sun
Do not aim the camera at the sun or point it at sun even if you are not
shooting.
Do not shoot intense iight
intense iight such as a spotight may cause a bloom or smear. A vertical stripe
may appear on the screen. However, this is not a malfunction.
Treat the camera with care
Do not drop the camera or subject it to strong shock of vibration. Otherwise,
the camera may malfunction.
-19-
Never touch internai parts
Do not touch the internal parts of the camera other than the parts specified.
Otherwise, the camera may malfunction.
Do not spiash water on the camera
Install the camera where the camera can be kept dry. If the camera gets wet,
turn off the power and contact your dealer.
Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than
specified. Otherwise, the quality of images may deteriorate or internal parts
may be affected. Special care is required to use the camera at high
temperature and humidity.
Shouid you notice any troubie
If any trouble occurs while you are using the camera, turn off the power
and contact your dealer. If you continue to use the camera when there
is something wrong with it, the trouble may much worse and an
unpredictable accident may occur.
10. IN CASE OF PROBLEMS
Condition Check Points
No image Are the camera and connected equipment turned on?
Is the iris of the lens adjusted properly?
• Are cables connected correctly?
Unnatural color
Is the monitor TV adjusted correctly?
Is the lighting too weak?
Unusual operation
of D/N mode
• Is the output of a power supply proper?
Press default to return the camera to factory settings (7.2.15)
-20-
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments