TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-M1612 DVD-ROM DRIVE USER MANUAL
8 NOTE: Use a bar that is less than 1.5 mm in diameter. Do not insert more than 50mm in depth. Inserting more than 50mm may damage the DVD-ROM dri
9 TROUBLESHOOTING – SD-M1612 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instruction
10 SPECIFICATIONS –SD-M1612 General Interface ATAPI Compatible DVD-ROM Standards DVD DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R, DVD-RW, DVD-RA
11 Performance Rotational Speed DVD-ROM (6.0X - 16X) single layer 9,200rpm (4.1X - 10X) dual layer 6,300rpm DVD-R (Ver 2.0), DVD-RW (2 - 4.8X)
12 Reliability MTBF 100,000 hours Power ON Hours 5,436 hours/year ON/OFF Cycles 313 cycles/yea Number of Access 600,000 accesses/year Operating D
13 Power DC Voltage and Current Requirements 5V 5%, 12V 5% +5V +12V Sleep Standby Idle Random Access (average) 280mA 300mA 580mA (DVD) 600mA (CD)
14 DRIVE CONNECTORS –SD-M1612 Figure 1.SD-M1612 DVD-ROM Drive Rear Panel - Connectors Power Connector Power is supplied to your DVD-ROM drive b
15 Table 1.Interface Pin Assignments INTERFACE PIN ASSIGNMENT PIN NO. I/O SIGNAL NAME HOST SIGNAL NAME PIN NO. I/O SIGNAL NAME HOST SIGNAL NAME 1
CONTENTS Introduction...1 Setup ...
1 INTRODUCTION – SD-M1612 DVD-ROM Drive General Features Tray Loading Mechanism 3-way Disc Eject (eject button, software, emergency eject hole) Av
CD • CD-DA • CD+(E)G • CD-MIDI • CD-TEXT • CD-ROM • CD-ROM-XA • CD-I Bridge (Photo-CD, Video CD) • CD-I • Multi-session (Photo-CD, CD
3 SETUP – SD-M1612 DVD-ROM The following steps must be performed to properly install your drive: • Set Drive Jumper Settings • Connect Audio Cab
4 Placing DVD-ROM Drive inside your Computer Now that you have set the jumpers, you are ready to install your DVD-ROM drive inside your computer. I
5 Audio Cable (optional) - If you have a sound card and speakers, and would like to play audio CDs on your computer, you will need to install a CD/DV
6 USING THE DVD DVD-ROM Drive – SD-M1612 Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is mounted horizontall
7 Removing a Disc To remove a disc from the DVD-ROM drive, perform the following steps: 1. Open the Loading Tray by pressing the Eject Button. 2.
Comments to this Manuals