Toshiba TLP-B2U User Manual download pdf (Page 26)

CONTENTS

Operations

Projection on the screen (Continued)

Select the input source.

On the remote control, press RGB or VIDEO.

On the control panel of the main unit, press INPUT

repeatedly.

Each time the button is pressed, the source indication on the

screen changes as follows:

: To project pictures from a computer connected to RGB

connector.

: To project pictures from a video player connected to VIDEO

connector or S-VIDEO connector.

(Signal sent from the computer)

• If you project an image from a computer with an LCD screen

while monitoring the image on the computer, the image may not

be projected properly, depending on the computer model.

In this case, turn off the computer display. For details on

controlling the computer display, etc., refer to the computer’s

manual and description on the software for the computer used.

• When a signal of the blackish screen whose edges are dark is

input, it may not be displayed normally. If this happens, input a

signal whose picture is bright and whose frame is clear, then

press the remote control unit’s RGB button again.

• The projector projects an image by XGA signal (1024 x 768) in

full screen.

• VGA, SVGA signal project the image by enlarging in full screen

size, the image quality could be slightly degraded. SXGA signal

can be projected since the projector has simplified compatibility

with them. (However, letters and lines can be inequal or a part

can be missing. Some signals may not be projected at all.)

• It is recommended to set an external monitor connected to the

computer to XGA mode (1024 x 768).

• The projector can be also applied to DDC2B (Display Data

Channel 2B). If your computer is applied to the DDC, start up

your computer after turning on the projector.

RGB

VIDEO

INPUT

Continued

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 66 67

No comments

Toshiba TLP-B2U User Manual Page 26