Toshiba Camileo BW10 User Manual download pdf (Page 24)

EN 11 User’s Manual

CAUTION

Do not charge the battery pack immediately after the camcorder has

been in continuous use for a long time

i The battery pack becomes hot when the camcorder is used continuously

for a long time. If you attempt to charge the battery pack in this state, the

multi-indicator may flash orange and it may not be possible to charge the

battery pack. Wait until the battery pack has cooled down before

attempting to charge it.

Does the battery pack appear swollen?

i The lithium-ion battery used in this camcorder may expand slightly when

stored in a hot environment or repeatedly used, but this is not a safety

hazard. However, a battery that is difficult to insert because it has become

swollen may then be impossible to extract from the battery compartment.

In this case, please discontinue its use and replace it with a new battery.

Do not use the battery with the outer covering or label removed

i Doing so may result in malfunction.

HINT

About the internal backup battery

i This camcorder’s internal battery serves to maintain the date and time

settings, as well as the shooting settings. The backup battery will be fully

charged when the battery pack is kept in the camcorder continuously for

about 2 days. In the fully charged state, the backup battery will maintain

the camcorder settings for about 7 days.

When not using the camcorder for a long time, remove the battery pack

i A small amount of power is still used even if the camcorder is turned off,

and it is therefore recommended that the battery pack be removed from

the camcorder if it is not going to be used for a long time. Note that when

the battery pack is removed for a long period, the time and date settings

may be cleared. Before using your camcorder again, be sure to confirm

that the camcorder settings are correct.

Recharging when connected to the USB terminal

i The battery can be recharged while the camcorder is connected to a

computer.

i Note, however, that the time it takes to recharge will differ depending on

the camcorder’s operating condition.

i Connect the dedicated USB interface cable to the USB connector on your

computer. Do not connect it to the USB connector on the monitor or the

keyboard, or to the USB hub.

i If the camcorder is not going to be used for an extended period of time,

please disconnect the dedicated USB interface cable from the camcorder.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 62 63

No comments

Toshiba Camileo BW10 User Manual Page 24