Toshiba Magnia 3100 User Manual download pdf (Page 66)

HW Diagnostics

SCSI HDD TEST

SCSI HDD TEST (HDD)

Status Error name Meaning

01 CHECK CONDITION OR BAD COMAND Bad command error

03 DRIVE SELECTION FAILED ID selection error

04 TARGET DRIVE BUSY The target drive is busy

05 SCSI BUS TIME OUT Time out error of SCSI bus

09 DMA BOUNDARY ERROR DMA BOUNDARY occurred

0D COMMAND TERMINATED A command terminated

0E QUEUE FULL Command queue is full

80 NO SENSE The sense data is invalid

81 RECOVERED ERROR The execution of the command has

correctly finished because of

recovery treatment.

82 NOT READY The condition does not satisfy for the

command execution

83 MEDIUM ERROR An error occurred because of the failure

of a medium

84 HARDWARE ERROR A hard error that is impossible

to recover occurred during

command execution

85 ILLEGAL REQUEST CBD is illegal

86 UNIT ATTENTION The function of hard disk drive has been

changed

87 DATA PROTECT Data protection error

89 VENDOR UNIQUE A unique error of disk maker

8A COPY ABORTED Stop of COPY command

8B ABORTED COMMAND The execution of a command

is correctly stopped

8C EQUAL The comparing result of the

search data command is

satisfied

8E MISCOMPARE Comparing command error

E0 STATUS ERROR Status error

F0 OTHER ERROR Other errors

FE NO DRIVE ERROR The target drive has not been found

FF DATA COMPARE ERROR Data comparing error

*Definition of SCSI HDD TEST Details Information (DETAILS = XXXXXXXXXXXXXXX)

NOTE: The [01. Sequential address read] tests all areas of the hard disk drive. If the capacities of

installed hard disk drives are large enough, the test may take a few hours.

If you do not know where the hard disk drives are connected (host ID, SCSI ID and channel number of

the SCSI controller), you can find them from [01. INQUIRY] of [09. SCSI TEST].

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 77 78

No comments

Toshiba Magnia 3100 User Manual Page 66