Toshiba TDP-MT400 User Manual download pdf (Page 11)

2120

Operations

English Français Español Deutsch Italiano

Português

Svenska

■ Turning the power on

Turn on the main power switch

The ON indicator will change to

orange, indicating standby mode.

• After the main power switch is turned

on, the inner cooling fan starts

cooling.

Press the ON/STANDBY

button.

The power turns on, and the following

3 green indicators light: ON, LAMP,

and FAN. After a moment, the start-up

screen appears.

(Orange)

p.43

Before connection

• Read the owner’s manual of the device you are connecting to the projector.

• Some types of computer cannot be used or connected to this projector.

Check for an RGB output terminal, supported signal

p.39

, etc.

•Turn off the power of both devices before connecting.

• The figure below is a sample connection. This does not mean that all of these devices

can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)

Notes

• If you want to feed the digital RGB signal, separately available DVI cable is needed.

• If you are using the digital RGB signal for input to this unit, some computer models or a

certain type of DVI cable may cause on rare occasions noise on the screen. If such is a

case, decrease your computer’s refresh rate or the resolution. It is also recommended to

use a DVI cable in 2 m or less in length.

Connection

Computer (for control)

VCR, etc

Video recorder,

DVD player, etc.

To RS-232C

terminal

Control cable

To video

output

Video cable (supplied)

To S-Video

output

S-Video cable

(supplied)

RGB component video cable

(not supplied)

To Y /C

B/CR output

Green (Y)/Blue (C

B)/Red (CR)

DVI cable

(not supplied)

To RGB output

Computer

DVD video recorder, etc.

Computer

RGB cable

(not supplied)

To DVI output

■ Connecting the power cord

Insert the power cord connector into the

AC IN socket of the projector.

Insert the power cord plug into a wall or

other power outlet.

Start-up screen

Control panel

Remote

Control

Power cord connector

(Supplied)

CAUTION

• Do not look into the lens while the lamp is on. The strong light from the lamp may cause

damage to your eyes or sight.

• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause

burns, deform/break the object.

■ Removing the lens cover

Be sure to remove the lens cover when the power is

turned on. If it is left on, it could become deformed due

to heat.

Turning the power on and off

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Comments to this Manuals

No comments

Toshiba TDP-MT400 User Manual Page 11

Comments to this Manuals

Related products and manuals for Projectors Toshiba TDP-MT400