Toshiba Tecra R10 User Manual download pdf (Page 72)

3-24 User’s Manual

TECRA R10

8. Seat the memory module cover in place and secure it with two screws.

Figure 3-9 Seating the memory module cover

9. Install the battery pack - refer to Replacing the battery pack section in

Chapter 6, Power and Power-Up Modes, if required.

10. Turn your computer over.

11. Turn the computer on and make sure the added memory is recognized -

to confirm it, Start -> Control Panel -> System and Maintenance

-> System icon.

Removing a memory module

To remove the memory module, follow the steps as detailed below:

1. Shut down the computer - make sure the Power indicator is off (refer to

the Turning off the power section in Chapter 1, Getting Started, if

required).

2. Remove the AC adaptor and all cables and peripherals connected to

the computer.

3. Close the display panel.

4. Turn the computer upside down and remove the battery pack (refer to

Replacing the battery pack section in Chapter 6, Power and Power-Up

Modes, if required).

5. Loosen the two screws securing the memory module cover in place -

please note that this screw is attached to the cover in order to prevent it

from being lost.

■ The slot A is reserved for the first memory module. Use the slot B for

expanded memory. If only one module is installed, use the slot A.

■ Align the grooves along the edges of the memory module with the

latches on the connector and insert the module into the connector

firmly - if you find it difficult to install the memory module, gently prise

the locking tabs outwards using the tip of your finger.

Please also ensure that you hold the memory module along its left and

right hand edges - the edges with the grooves in.

Take care to ensure that the memory module cover is firmly closed.

Screws

Memory module

cover

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 221 222

No comments

Toshiba Tecra R10 User Manual Page 72