Toshiba DVD-ROM SD-C2612 User Manual Page 1

TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-C2612 DVD-ROM MOBILE DRIVE USER MANUAL

8 Transfer Rate DVD (Single) 4,463 - 10,820 Kbytes/s (3.3X - 8X) DVD (Dual) 3,380 - 8,112 Kbytes/s (2.5X - 6X) DVD-Video 2,298 - 5,408 Kbytes/s

9 Power DC Voltage and Current Requirements +5V ±5% (Operating), 8% (start-up) Physical Height 0.5" (12.7mm) Width 5.04" (128mm) Dept

10 Drive Connectors –SD-C2612 Figure 1.SD-C2612 DVD Writeable Drive Rear Panel – Connector ATAPI Connector A 50-pin ATAPI interface connector i

CONTENTS Introduction...1 Setup ...

1 INTRODUCTION – SD-C2612 General Features 100ms Average Access Time (DVD) Lead (Pb) Free Printed Circuit Board Multimedia PC-3 Spec Compliant RPC2

Eject Button The EJECT button is used to open the disc tray so you can install or remove a disc Busy Indicator When you install a disc into the DVD

3 SETUP – SD-C2612 Toshiba recommends that only trained professionals install this DVD-ROM drive into your laptop/notebook. Installation Notes •

4 USING THE DVD-ROM Drive – SD-C2612 Drive Operation Inserting Media – Horizontally or Vertically To insert a DVD in a DVD-ROM drive that is mount

5 Regional Coding Region Protection Coding (RPC) of DVD Discs: this feature is supported on DVD Players and is used with DVD-Video Discs (i.e. movies

6 TROUBLESHOOTING – SD-C2612 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instruction

7 SPECIFICATIONS –SD-C2612 General Interface: ATAPI Compatible DVD-ROM Standard - Read: DVD: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (ver 1.0